I'm planning to use a LP5912-Q1 (3.3V variant) in a SIL-2 system. For my documentation I need to calculate the absolute min/max output voltage under all conditions. This includes initial accuracy, ...

What is the voltage output of AWR2243 VBGAP if I provide 1.8V to VIOIN? I want to know the source of VBGAP come from which pin?which means when I connect this pin to ground, then VBGAP should output ...

I want to use SBL_SD to initialize my EVM. Could you provide a detailed process on how to flash SBL_SD onto an SD card for booting? By the way, is it sufficient to flash just the ...

I am using OrCAD X Capture 23.1 (trial version), and the PSpice for TI is installed on my computer at the same time. Errors about netlisting errors appear, as following: INFO(ORNET-1041): Writing ...

hi i only compiler cpu1 why load to cpu2? my only load cla_ex4_pwm_control for p65 cpu1 project,why load to cpu2? how to modify the project? (If you connected previously, may have to resume CPU2 to ...

Thank you for submitting your query. I'll gladly assist you in resolving the Compliance and EMC issues you are facing. As a heads up, both of these issues can be affected by many factors. I want to ...

3. Output current capability > 1.1A (application scenario: at 25°C, the TEC internal resistance is 1.229Ω~1.502Ω); 4. It is best to support NTC detection function.

During the process of adding a new driver in TDA4 VM, we found that there was an interrupt when reading or writing to the sensor register address 0xffff, which means that the subsequent sensor ...

The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.

Please see the attached one it can't start the sim,and seem still can't sim 0V when AC1 touch the ground(0V) ...

Can you please provide some guidance regarding the PCB Layout mentioned on page 36 of the THS4561’s data sheet. I am using the WQFN 10 pin package (the diagram on page 36 only shows the layout for the ...

I am currently using the DRV8912. The half-bridge high-side switch is enabled and mapped to a PWM channel. The duty cycle is 100%. The MCU only communicates via SPI during the initialization phase and ...