I'm planning to use a LP5912-Q1 (3.3V variant) in a SIL-2 system. For my documentation I need to calculate the absolute min/max output voltage under all conditions. This includes initial accuracy, ...

I am using OrCAD X Capture 23.1 (trial version), and the PSpice for TI is installed on my computer at the same time. Errors about netlisting errors appear, as following: INFO(ORNET-1041): Writing ...

LM5050-1 cannot drive back-to-back FETs and can only drive an ideal diode FET. (+) [FAQ]: Can LM5050-1, LM74700-Q1 or TPS241x controllers drive two back-back MOSFETs - Power management forum - Power ...

hi i only compiler cpu1 why load to cpu2? my only load cla_ex4_pwm_control for p65 cpu1 project,why load to cpu2? how to modify the project? (If you connected previously, may have to resume CPU2 to ...

3. Output current capability > 1.1A (application scenario: at 25°C, the TEC internal resistance is 1.229Ω~1.502Ω); 4. It is best to support NTC detection function.

What is the voltage output of AWR2243 VBGAP if I provide 1.8V to VIOIN? I want to know the source of VBGAP come from which pin?which means when I connect this pin to ground, then VBGAP should output ...

Thank you for submitting your query. I'll gladly assist you in resolving the Compliance and EMC issues you are facing. As a heads up, both of these issues can be affected by many factors. I want to ...

Hello, I have a question regarding my DSP28377D board. It has been running normally for some time, but occasionally (it has happened many times, with a probability of about 1%) the program fails to ...

During the process of adding a new driver in TDA4 VM, we found that there was an interrupt when reading or writing to the sensor register address 0xffff, which means that the subsequent sensor ...

We are working on DRA821U CPU with Linux SDK 09.02, we are facing issue with sd voltages switching in uboot, Here is the senario,initially detects with UHS mode, but once we launch "mmc rescan" again ...

I am encountering MibSpi3 RxBuf value not consistent with the SPI log. My situation is: the SPI3 is shared between TI TPS65381A-Q1 (psu) and Microchip MCP3208 (adc), and we implemented semaphore for ...

I want to use SBL_SD to initialize my EVM. Could you provide a detailed process on how to flash SBL_SD onto an SD card for booting? By the way, is it sufficient to flash just the ...