I'm planning to use a LP5912-Q1 (3.3V variant) in a SIL-2 system. For my documentation I need to calculate the absolute min/max output voltage under all conditions. This includes initial accuracy, ...

What is the voltage output of AWR2243 VBGAP if I provide 1.8V to VIOIN? I want to know the source of VBGAP come from which pin?which means when I connect this pin to ground, then VBGAP should output ...

I want to use SBL_SD to initialize my EVM. Could you provide a detailed process on how to flash SBL_SD onto an SD card for booting? By the way, is it sufficient to flash just the ...

I am using OrCAD X Capture 23.1 (trial version), and the PSpice for TI is installed on my computer at the same time. Errors about netlisting errors appear, as following: INFO(ORNET-1041): Writing ...

hi i only compiler cpu1 why load to cpu2? my only load cla_ex4_pwm_control for p65 cpu1 project,why load to cpu2? how to modify the project? (If you connected previously, may have to resume CPU2 to ...

Thank you for submitting your query. I'll gladly assist you in resolving the Compliance and EMC issues you are facing. As a heads up, both of these issues can be affected by many factors. I want to ...

3. Output current capability > 1.1A (application scenario: at 25°C, the TEC internal resistance is 1.229Ω~1.502Ω); 4. It is best to support NTC detection function.

During the process of adding a new driver in TDA4 VM, we found that there was an interrupt when reading or writing to the sensor register address 0xffff, which means that the subsequent sensor ...

Hello, I have a question regarding my DSP28377D board. It has been running normally for some time, but occasionally (it has happened many times, with a probability of about 1%) the program fails to ...

I wonder should we consider DC bias for the values of the capacitors on Table 7-1? If so, we should use larger capacitor values than listed on the table? I'm not sure I understand your concern with DC ...

Kindly review the schematic of BQ2980 along with fuel guage IC BQ27Z561fuel guage IC and TPS2121 power path IC. I am bit confused regarding GND connectionSCH_Schematic1_3-PowerSection_2024-09-18.pdf ...

I'd like to connect to the TMS320F280037 with XDS200 Debug Probes while my program is running without flashing new code and without halting the operation. From reading other posts, I have tried the ...