I'm planning to use a LP5912-Q1 (3.3V variant) in a SIL-2 system. For my documentation I need to calculate the absolute min/max output voltage under all conditions. This includes initial accuracy, ...

What is the voltage output of AWR2243 VBGAP if I provide 1.8V to VIOIN? I want to know the source of VBGAP come from which pin?which means when I connect this pin to ground, then VBGAP should output ...

I want to use SBL_SD to initialize my EVM. Could you provide a detailed process on how to flash SBL_SD onto an SD card for booting? By the way, is it sufficient to flash just the ...

I have a question about VC and CB pins. I know I can use GPIO3 - GPIO11 as NTC / Analog input / Digital control, however, can I use either VC or CB pin for NTC? For example, battery cells are ...

I am using OrCAD X Capture 23.1 (trial version), and the PSpice for TI is installed on my computer at the same time. Errors about netlisting errors appear, as following: INFO(ORNET-1041): Writing ...

hi i only compiler cpu1 why load to cpu2? my only load cla_ex4_pwm_control for p65 cpu1 project,why load to cpu2? how to modify the project? (If you connected previously, may have to resume CPU2 to ...

Thank you for submitting your query. I'll gladly assist you in resolving the Compliance and EMC issues you are facing. As a heads up, both of these issues can be affected by many factors. I want to ...

3. Output current capability > 1.1A (application scenario: at 25°C, the TEC internal resistance is 1.229Ω~1.502Ω); 4. It is best to support NTC detection function.

During the process of adding a new driver in TDA4 VM, we found that there was an interrupt when reading or writing to the sensor register address 0xffff, which means that the subsequent sensor ...

I see this message when I try to select an I2C channel other than I2C_6, I cannot identify the cause of this problem, the PINs that I want to configure are free. Attached is the project that I am ...

I am testing the Xlinx JESD204-IP for interfacing the AFE7950EVM. My evaluation board is zcu102 and I connect afe7950evm to the HPC1 of zcu102. I am trying to use 8b/10b in the mode of subclass 1. I ...

I tried to load a simple program on EK-TM4C1294XL LaunchPad as well as DK-TM4C129X EVM on a Windows 11 machine and there is no issue. See below image. The easiest way for you to test is to plug in ...